|MK220 Electronic Control Pad for steam showers.
This item comes with pre-fitted cable to connect to the steam generator unit via a pinned plug data connection.
Enables control of Steam timer, lights, radio, fan, ozone.
Size: 220mm x 70mm
Fitting hole dimensions: 200mm x 60mm
of this item is as simple as removing the 4 fixingbolts holding the pad
in place and pushing the pad into the shower cabin fromthe rear of the
shower. Clean the area of any silicone used to provide waterprotection,
apply a new bead of sealant to bed the pad into, place the pad
inposition, re-fasten the bolts and connect the data lead. Clean up any
excesssealant and power the system back up.
UPGRADING YOUR CONTROL PAD
replacing control pads you MUST replace with the same pad as the
connectionsfrom the pad can be different to those on the steam generator
or electronics.Additionally the data communication to and from the
generator must correspond (think of it like pointing a television remote
at a different Make/Model of television, the remote would not control
the television correctly)
If you wish to upgrade your control pad
to a later generation, then you MUSTpurchase a corresponding steam
generator system. This may require modificationto the tower panel of
your shower to house the control pad that may be aslightly different
shape or size.